Replacement drive with frequency control suitable for Econoroll

Replacement Drive with Frequency Control for Crawford Econoroll High Speed ​​Doors

• Frequency control: This drive is equipped with frequency control, which makes the speed of the drive variable and adaptable to different applications. The speed ranges are as follows:

  • OPEN : 25-160 revolutions per minute (rpm)
  • CLOSE >2.5m : 25-100 rpm
  • CLOSE <2.5m : 25-90 rpm

• Torque: The operator has a torque of 60 Nm, which indicates the force with which it can open and close the door.

• Shaft Hole: The shaft hole has a diameter of 25.0 mm, which is the size of the shaft used to connect the operator to the door.

• Voltage: The drive is available for both single-phase (1x230V) and three-phase (3x400V) power supplies.

• Digital Limit Switch DES: This indicates that the operator uses digital limit switches to detect the position of the door when it is fully opened or closed.

• Maximum Door Size: This operator is suitable for door sizes up to 3000 mm x 3000 mm.

• Catching torque: The operator has a catching torque of 310 Nm, which indicates the force with which it can stop the door when opening or closing.

Included Components:

• Drive
• Control cabinet TS971
• 5 meter connection cable

This complete unit makes it easy to install and operate the operator for Crawford Econoroll E500, E1000, E1200 and E1500 high speed doors.

When installing and using this actuator, it is important to carefully follow the manufacturer's instructions and recommendations for safe and efficient operation. It may also be necessary to consult a qualified technician for installation, depending on the complexity of the system.